Switched mode power supply manufacturer

Switched Mode Power Supply Manufacturer

Total Power Europe has the disposal of its own progressive and high quality production company in Taiwan. Our ISO certified Taiwanese manufacturer TekPower International Co., Ltd acts as the logistic and technical centre of a fixed group existing of approved and regularly audited subcontractors, resulting in the available employment of over 240 people. This set up makes the organisation very flexible. Within this group the following production disciplines are carried out:

Metalwork
Inductive component assembly
Wiring assemblies
Printed Circuit Board (PCB) manufacturing/assembly
Surface-mounted device (SMD), conventional automatic and manual placement

Our production headquarter itself has the overall production management responsibilities. The final assembly, hi-pot, burn-in and final test activities are carried out on their site. The outcome of the production travel card and the final test data will be stored for at least 5 years. Furthermore, all material sources for every individual power supply are fully traceable.

ISO 9001:2000 Quality Management System

In 1999, our production achieved the ISO 9002:1994 certification. This certificate was updated and assessed by the BSI in 2001 according to the management standard BS EN ISO 9001:2000.

ISO 14001:2004 Environmental Management System

Since 2004, TekPower is manufacturing power supplies, which are lead free and according to RoHS directives. TekPower obtained the environmental management system ISO 14001:2004 certificate in 2006. In order to check the presence of any hazardous substance, TekPower acquired the Hazardous Substance Monitor SEA1000A.

ISO 26000 Social responsibility

TekPower is following the ISO 26000 standard on social responsibility. This standard provides guidance to organisations on how they can operate in a socially responsible manner.

Quality Assurance
The complete production quality assurance includes:

A customer and manufacturer approval for all intended changes in the design by using an official Engineering Change Proposal
Inspection and acceptance of incoming parts and components on an Acceptable Quality Level (AQL) base (MIL-105D)
In process production quality control
Final test, Hi-pot and burn-in on all produced units
Full traceability for at least 5 years.

Production for third parties

Due to a nearly unlimited production capacity in Taiwan, our organisation is very suitable in adopting the complete technical coordination and logistics of any required sub-assembly or end-product.

Additional services

Depending on the customer requirements we can take care of a complete individual measuring report, a full traceability of used components, distribution, special packaging and European based incoming inspection.